Join us at Base Camp WNC in the picturesque North Carolina foothills as we demonstrate the step-by-step process of setting up a spring water system. From locating the spring to building a spring box, installing filters, and pumping water uphill, this instructional guide will equip you with the knowledge to create your own sustainable and pure spring water setup. Welcome to Base Camp WNC, where we embark on an exciting journey to set up a spring water system in the beautiful North Carolina foothills. Today, we'll show you how to capture and pump spring water uphill, providing you with a reliable and refreshing water source right on your property. Let's get started with the following steps: Step 1: Locating the Spring Begin by locating a natural spring on your property that has a consistent flow of water throughout the year. Ensure the spring doesn't dry up during the hot summer months. Once you find the perfect spot, proceed to the next step. Step 2: Building the Spring Box Dig out a suitable space for the spring box, allowing the water to flow into it naturally. Use plastic sheeting to line the box, ensuring a non-pressurized system. This setup will prevent freezing during the winter, ensuring a steady water flow all year round. Step 3: Installing Filters Now, it's time to filter the spring water to keep it clean and pure. Use plain sediment filters, readily available at Lowe's or similar stores. These filters will effectively remove any impurities and particles, ensuring you have access to pristine spring water. Step 4: Setting Up the Pump Install a pump to pump the spring water uphill, if necessary. To prevent any issues with freezing during winter, create a non-pressurized system. Drill a small 1/8 inch hole in the bulkhead fitting at the top of the tank. This will allow water to drain back into the tank during the winter when the pump is not in use. Step 5: Sanitizing the Spring Ensure the spring remains clean and free from contaminants by adding a sanitizing pipe to the setup. Mount the pipe with holes on the bottom in the gravel near the spring box. This setup will allow you to sanitize the entire spring by pouring bleach water through the cap. Step 6: Finishing Touches Complete the setup by backfilling and covering the spring box with suitable materials. Ensure everything is secure and leak-free. Perform a final test to check if the water is flowing correctly and if there are any issues that need attention. Congratulations! You've successfully captured and pumped spring water uphill to create your own sustainable water system. Enjoy the natural and refreshing taste of spring water right at your doorstep. Feel free to share your newfound knowledge with friends and family, and don't hesitate to reach out if you need further assistance in designing or installing your spring water setup. Happy pumping! For Additional information on setting up your own spring system, contact us:
0 Comments
Leave a Reply. |
Archives
July 2024
Categories
|